Polypac I-700 coagulant is effective in a wide variety of industrial, paper mill water and wastewater treatment applications.

Properties

Appearance           : colourless to light yellow liquid
Density (kg/m3)    : 1450
pH (neat)              :  < 2.0
Flash Point            : none

These values are to be seen as typical values and should not be considered as specifications.

Application

Polypac I-700 has been successfully applied in the treatment of potable water, oily wastewater, secondary clarification, colour removal, paper mill save-all systems, refuse thickening in coal preparation plants, greasy tower treatment and phosphate removal.

Dosage

Best results will be obtained when the product is diluted at least 10:1 prior to use. Diluting the product is beneficial because it will have better distribution into the waste stream with less chance of a localised overdose. In-line dilution with a static mixer is best, but if a holding tank is used for product dilutions, the dilution tank should be used within 2 days.

The addition of Polypac I-700 coagulant to a waste stream consumes alkalinity and the pH may decrease. Best results will be obtained if the system pH is readjusted to 5.0 – 8.0 after the product has been added and given a chance to mix.                                                                                 

Handling

Polypac I-700 has a shelf life of two years in unopened containers. Should the product freeze, allow it to thaw thoroughly and mix well before attempting to feed.
This product is corrosive to both eyes and skin and causes burns. Do not get in eyes on skin or clothing. Wear protective gloves, goggles and protective outer clothing while handling. Avoid breathing vapour. Keep container closed. Use with adequate ventilation. Wash thoroughly after handling.

Cross-linked polyethylene, fiberglass, stainless steel and lined steel are the preferred materials of construction for storage tanks. Avoid natural rubber and Buna-N gaskets as these materials swell when placed in contact with the neat product. Stainless steel, VITON and TEFLON materials are the best choices for pump heads. For feed lines use PVC or reinforced tubing made of TYGON material.

Wear suitable protective gloves and safety goggles.
In case of contact immediately flush with plenty of water. After eye contact seek medical advice.

Packaging

This product is available in a variety of packaging sizes such as pails, drums, bulk, and Intermediate Bulk Containers (IBC). 

Your Icbina representative will recommend the appropriate packaging for the application.

Important Information

Typical Properties:  Refer to MSDS.

Regulatory Information:  Please refer to the MSDS or contact your sales representative for any additional regulatory and environmental information.

Safety:  Icbina maintains Material Safety Data Sheets on all of its products. Material Safety Data Sheets contain health and safety information for your development of appropriate product handling procedures to protect your employees and customers.

Our Material Safety Data Sheets should be read and understood by all of your supervisory personnel and employees before using Icbina products in your facilities.